Advice on Table Saw Cradle

[https://imgur.com/a/yJLJk6s](https://imgur.com/a/yJLJk6s)

I’m trying to integrate my table saw into my work table. As part of this, I’d like to have an attachment underneath that leads to my dust collector in order to help manage the sawdust. I tested it out today and I don’t think it was actually getting much of the sawdust. I checked the suction and it seemed fine, but as you can see from the pictures, there’s quite a bit that is just sitting on the surface where the saw sits. Do I need to somehow connect the hose to that port that hangs under the blade?

I don’t expect this to get 100% of the dust, but I was hoping it would start getting most of it.


Leave a Reply

Your email address will not be published. Required fields are marked *

Show Buttons
Hide Buttons